Ara
Toplam kayıt 75, listelenen: 61-70
Challenges in Additive Manufacturing Technology: Post Processing, Design and Material’s Selection
(Springer Nature, 2023)
It is important to bear in mind that additive manufacturing (AM) did not emerge in isolation but rather built upon earlier technologies. The rapid adoption of 3D printing technology across industries serves as a testament ...
Thermoplastic Polymers and Polymer Composites Used in Selective Laser Sintering (SLS) Method
(Springer, 2023)
Selective laser sintering (SLS) is a powder bed fusion
(PBF) additive manufacturing (AM) technique that uses
high-energy beams (laser beams, electron beams, or an
infrared panel heater) to coalescence (or melt) ...
Corrosion Behaviour of Additive Manufactured Metals
(Springer, 2023)
Additive manufacturing is the production process in which a 3D CAD model is combined into layers, and the material is turned into a physical part. Additive manufacturing is an important technology that is very popular and ...
Heat Treatment of Additive Manufactured Metals
(Springer, 2023)
Additive manufacturing systems, which have strict control
processes before and after manufacturing, are used in many
industries. The quality of the machine’s equipment and raw
materials used directly affect the production ...
The Comparison of Pullout Strengths of Various Producing Methods for Internal Screw Threads of Additive Manufactured Metal Parts
(Springer, 2023)
Thread fastening is the primary method of joining components to construct a final product. Since thread coupling exists in
many different industrial applications, this study aims to identify the proper manufacturing steps ...
Microstructural, Hardness, and Wear Properties of Mg2Si-reinforced Al Matrix in-situ Composites Produced by Low Superheat Casting
(Elsevier, 2024)
In this study, Mg2Si-reinforced A356 and A413 aluminum matrix composites were fabricated by low superheat
casting using AM50 magnesium alloy as a source for the in-situ formation of Mg2Si particles. AM50 was added to
each ...
Nanocomposites and Nanohybrids in Additive Manufacturing
(De Gruyter, 2023)
Additive manufacturing (AM) has undergone significant technological development since its emergence in the 1970s. This development is expected to continue and
take an important place in the manufacturing sector. Developing ...
Development of an Alternative Heat Treatment to the Traditional T6 Heat Treatment of AlSi10Mg Alloy Produced by Additive Manufacturing
(Springer, 2024)
In this study, alternative solution heat treatments, applied at lower temperatures and shorter times, were
applied to AlSI10Mg samples produced with the powder bed laser fusion technique. Thermocalc software
was used to ...
Electrochemical Corrosion Behaviour of UNS S32205 Duplex Stainless Steel Dependent on Sigma Phase Precipitation
(De Gruyter, 2024)
In this study, the microstructure and electrochemical corrosion behavior of the UNS S32205 alloy were investigated. Firstly, the phase diagram of the studied samples was determined by Thermo-Calc 2022 software, and the ...
Influence of High-Velocity Oxy-fuel Sprayed Cr3C2-NiCr Coating on Corrosion and Wear Properties of AISI 2205
(Springer, 2024)
In this study, Cr3C2/10%NiCr layer was deposited on the AISI 2205 duplex stainless steel by the HVOF
technique. Microstructural, tribological and corrosion behaviors of the coated and uncoated samples were
investigated. ...