Ara
Toplam kayıt 7, listelenen: 1-7
Selective Laser Sintering Manufacturing and Characterization of Lightweight PA 12 Polymer Composites with Different Hollow Microsphere Additives
(Springer, 2021)
The use of additives in polyamide polymeric SLS built frameworks further reinforces the goal of developing
lightweight components, which serves as the basis for the current investigation. In this paper, different
amounts ...
Estimation of Surface Roughness in Selective Laser Sintering Using Computational Models
(Springer, 2022)
This study presents a comprehensive experimental dataset and a novel classification model based on Deep Neural Networks
to estimate surface roughness for additive manufacturing. Many problems exist due to the very complex ...
Dry Sliding Wear Behavior of Energy Density Dependent PA 12/Cu Composites Produced by Selective Laser Sintering
(De Gruyter, 2023)
The selective laser sintering process is widely
used to fabricate polyamide matrix composites. Although
various reinforcements are used to produce polyamide
matrix composites, metallic-based reinforcements are used
to ...
Thermoplastic Polymers and Polymer Composites Used in Selective Laser Sintering (SLS) Method
(Springer, 2023)
Selective laser sintering (SLS) is a powder bed fusion
(PBF) additive manufacturing (AM) technique that uses
high-energy beams (laser beams, electron beams, or an
infrared panel heater) to coalescence (or melt) ...
Investigation of Wear Behavior of PA 12 Matrix Ceramic Reinforced Composites Produced by Selective Laser Sintering Method
(Gazi University, 2024)
In this study, ceramic-reinforced PA 12 matrix composites were fabricated by using Selective Laser
Sintering (SLS) additive manufacturing method with different energy density values. Additionally, dry
sliding wear tests ...
Electrochemical Corrosion Behaviour of UNS S32205 Duplex Stainless Steel Dependent on Sigma Phase Precipitation
(De Gruyter, 2024)
In this study, the microstructure and electrochemical corrosion behavior of the UNS S32205 alloy were investigated. Firstly, the phase diagram of the studied samples was determined by Thermo-Calc 2022 software, and the ...
Influence of High-Velocity Oxy-fuel Sprayed Cr3C2-NiCr Coating on Corrosion and Wear Properties of AISI 2205
(Springer, 2024)
In this study, Cr3C2/10%NiCr layer was deposited on the AISI 2205 duplex stainless steel by the HVOF
technique. Microstructural, tribological and corrosion behaviors of the coated and uncoated samples were
investigated. ...