Investigation of Wear Behavior of PA 12 Matrix Ceramic Reinforced Composites Produced by Selective Laser Sintering Method
Citation
KISASÖZ, Burçin ÖZBAY, İbrahim TÜTÜK, Ebubekir KOÇ, Sencer Süreyya KARABEYOĞLU & Alptekin KISASÖZ. "Investigation of Wear Behavior of PA 12 Matrix Ceramic Reinforced Composites Produced by Selective Laser Sintering Method". Journal of the Faculty of Engineering and Architecture of Gazi University, 39.2 (2024): 1029-1035.Abstract
In this study, ceramic-reinforced PA 12 matrix composites were fabricated by using Selective Laser
Sintering (SLS) additive manufacturing method with different energy density values. Additionally, dry
sliding wear tests were performed at 25 mm/sec and 100 mm/sec velocity values and at 5 N and 20 N wear
load values. In conclusion with the tests, it was found that when energy density increases the wear rate
increases. The wear rate values are given in Table A.
